Standard Test Method for Density and Void Content of Hardened Pervious Concrete
1.1 This test method provides a procedure for determining the density and void content of hardened pervious concrete specimens.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
5.1 This test method is applicable to pervious concrete mixtures containing coarse aggregate with a nominal maximum size of 25 mm [1 in.] or smaller.
5.2 This test method applies to either core specimens or molded cylinders.
5.3 Density and void content determined by other test methods may produce different numerical results, which may not be comparable.
5.4 This test method allows one to choose one of two different drying methods. The following should be considered in selecting Drying Method A or B.
Note 1: It is believed that exposure to high temperatures, as used in Drying Method B, may alter the void structure of the pervious concrete matrix by causing shrinkage cracks in the cement paste at the aggregate interface.
Failed to load document history.
| Publish Date | Document Id | Type | View |
|---|