ASTM C534/C534M-26

Current Revision
Standard Specification for Preformed Flexible Elastomeric Cellular Thermal Insulation in Sheet and Tubular Form

Best Price Guarantee Apr 15, 2026 English 6 Pages


Sub Total (1 Item(s)) $ 0.00
Estimated Shipping $ 0.00
Total (Pre-Tax) $ 0.00

You own the digital copy of this edition

View in Library
or
ASTM International Logo

ASTM C534/C534M-26

Standard Specification for Preformed Flexible Elastomeric Cellular Thermal Insulation in Sheet and Tubular Form

PUBLISH DATE 2026
PAGES 6
ASTM C534/C534M-26

This specification covers sheet and tubular preformed flexible elastomeric cellular thermal insulation.

The materials are classified into three grades according to the operating temperature range of the industrial systems that each material is used for.

The non-thermoplastic, thermoset products should be made of natural or synthetic rubber that may be modified using various thermoplastic or thermosetting resins, plasticizers, modifiers, antioxidants, curatives, blowing agents, and other additives.

All products should be tested using the prescribed procedures and conform to the specified values of apparent thermal conductivity, water absorption, water-vapor permeability, and linear shrinkage.

1.1Β This specification covers preformed flexible elastomeric cellular-thermal insulation in sheet and tubular form. Grade 1 covers materials to be used on commercial or industrial systems with operating temperatures from –183 to 104Β°C [–297 to 220Β°F], Grade 2 covers material used on industrial systems with operating temperatures from –183 to 150Β°C [–297 to 300Β°F], and Grade 3 covers material used on industrial systems with operating temperatures from –183 to 120Β°C [–297 to 250Β°F] where a maximum of 200 ppm of leachable chlorides and fluorides are permitted.

1.2Β The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3Β This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4Β This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Loading...

Failed to load document history.

Publish Date Document Id Type View