ASTM D2013/D2013M-26

Current Revision
Standard Practice for Preparing Coal Samples for Analysis

Best Price Guarantee Sep 1, 2026 English 15 Pages


Sub Total (1 Item(s)) $ 0.00
Estimated Shipping $ 0.00
Total (Pre-Tax) $ 0.00

You own the digital copy of this edition

View in Library
or
ASTM International Logo

ASTM D2013/D2013M-26

Standard Practice for Preparing Coal Samples for Analysis

PUBLISH DATE 2026
PAGES 15
ASTM D2013/D2013M-26

1.1 This practice covers the reduction and division of gross or divided samples, and the preparation of composite samples, up to and including the individual portions for laboratory analysis.

1.2 Reduction and division procedures are prescribed for coals of the following groups:

  • 1.2.1 Group A includes coals that have been cleaned in all sizes.
  • 1.2.2 Group B includes all other coals. Unknown coals are to be considered under Group B.
  • 1.2.3 Group A allows smaller weight laboratory samples to be retained than Group B. These lower weights may be used for particular coals if they have been shown, by using the procedures of A1.2, to give a sample preparation and analysis variance which is no more than 20 % of the total analysis variance.

1.3 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

5.1 Practices D2234/D2234M and D7430/D7430M give guidance on collection of a gross sample before crushing.

The mass and top size of the gross or divided sample collected by using these guides and practices are usually too large for chemical or physical testing. Practice D2013/D2013M provides instructions for reducing and dividing the gross or divided sample, by on-line or off-line processes, or both, to a top size and mass suitable to the performance of testing.

Because of the variability of coal and the wide variety of sample preparation equipment, caution should be used for all reduction and division processes to minimize bias in the final sample mass. Therefore, carefully select the standard to be used to collect the gross sample.

5.2 Division and reduction of a sample may occur at more than one location. Most often, the sample is collected, reduced, and divided (one or more times) by use of a mechanical sampling system.

The remaining sample may be further divided on-site to facilitate transporting it to the laboratory where further reduction and division may occur before analysis.

5.3 In places, this practice requires air drying the sample before subsequent reduction. Procedures for air drying and air-dry loss determination are provided in Test Method D3302/D3302M.

5.4 Most often, samples are reduced and divided to the analysis sample mass. However, some tests may require a sample of different mass or top size.

This procedure may be used to provide a sample of any mass and size consist from the gross or divided sample to, and including, the analysis sample.

5.5 This practice also specifies how to prepare composite samples, if required.

Loading...

Failed to load document history.

Publish Date Document Id Type View