ASTM D3019/D3019M-17(2024)

Current Revision
Standard Specification for Lap Cement Used with Asphalt Roll Roofing, Non-Fibered, and Fibered

Best Price Guarantee May 1, 2024 English 2 Pages

Sub Total (1 Item(s)) $ 0.00
Estimated Shipping $ 0.00
Total (Pre-Tax) $ 0.00

You own the digital copy of this edition

View in Library
or
ASTM D3019/D3019M-17(2024) PDF Preview
ASTM D3019/D3019M-17(2024)

This specification covers the physical requirements and testing of three types of lap cement for use with asphalt roll roofing.

Type I is a brushing consistency lap cement intended for use in the exposed-nailing method of roll roofing application, and contains no mineral or other stabilizers. This type is further divided into two grades, as follows:

  • Grade 1, which is made with an air-blown asphalt;
  • Grade 2, which is made with a vacuum-reduced or steam-refined asphalt.

Both Types II and III, on the other hand, are heavy brushing or light troweling consistency lap cement intended for use in the concealed-nailing method of roll roofing application, only that:

  • Type II cement contains a quantity of short-fibered asbestos,
  • while Type III cement contains a quantity of mineral or other stabilizers, or both, but contains no asbestos.

The lap cements shall be sampled for testing, and shall adhere to specified values of the following properties:

  • water content;
  • distillation (total distillate at given temperatures);
  • softening point of residue;
  • solubility in trichloroethylene; and
  • strength at indicated age.

1.1Β This specification covers lap cement consisting of asphalt dissolved in a volatile petroleum solvent with or without mineral or other stabilizers, or both, for use with roll roofing. The fibered version of these cements excludes the use of asbestos fibers.

1.2Β The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.3Β The following precautionary caveat applies only to the test method portion, Section 6, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4Β This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Loading...

Failed to load document history.

Publish Date Document Id Type View