ASTM D3288/D3288M-20

Current Revision
Standard Test Methods for Magnet-Wire Enamels

Best Price Guarantee Aug 1, 2020 English 7 Pages


Sub Total (1 Item(s)) $ 0.00
Estimated Shipping $ 0.00
Total (Pre-Tax) $ 0.00

You own the digital copy of this edition

View in Library
or
ASTM D3288/D3288M-20 PDF Preview
ASTM D3288/D3288M-20

1.1 These test methods cover testing liquid enamel coatings used to produce film-insulated magnet wire.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.3 The test methods appear as follows:

  • Density: 6 – 10
  • Determined Solids: 16 – 22
  • Effective Solids: 31 – 37
  • Flash Point: 11 – 15
  • Infrared Analysis: 45 – 50
  • Stack Loss: 23 – 30
  • Viscosity: 38 – 44

1.4 There is no known IEC equivalent document.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

1.1 These test methods cover testing liquid enamel coatings used to produce film-insulated magnet wire.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.3 The test methods appear as follows:

  • Density: Sections 6 – 10
  • Determined Solids: Sections 16 – 22
  • Effective Solids: Sections 31 – 37
  • Flash Point: Sections 11 – 15
  • Infrared Analysis: Sections 45 – 50
  • Stack Loss: Sections 23 – 30
  • Viscosity: Sections 38 – 44

1.4 There is no known IEC equivalent document.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

4.1 These tests are useful for specification and control purposes during the manufacture, purchase, and use of the magnet-wire enamels, and for determining uniformity of batches.

Loading...

Failed to load document history.

Publish Date Document Id Type View