Procedures for ensuring the cleanliness of industrial-process measurement and control equipment in oxygen service

Pre-heat requirements for starterless tubular fluorescent lamps

Glass bulb designation system for lamps

A method of temperature-rise verification of low-voltage switchgear and controlgear assemblies by calculation

Insulating materials - Industrial rigid laminated sheets based on thermosetting resins for electrical purposes - Part 4: Typical values

Photovoltaic devices - Part 14: Guidelines for production line measurements of single-junction PV module maximum power output and reporting at standard test conditions

Short-circuit currents in three-phase a.c. systems - Part 1: Factors for the calculation of short-circuit currents according to IEC 60909-0

Short-circuit currents in three-phase a.c. systems - Part 2: Data of electrical equipment for short-circuit current calculations

Short-circuit currents in three-phase AC systems - Part 4: Examples for the calculation of short-circuit currents

Performance of high-voltage direct current (HVDC) systems with line-commutated converters - Part 1: Steady-state conditions

Performance of high-voltage direct current (HVDC) systems with line-commutated converters - Part 2: Faults and switching

Amendment 2 - Performance of high-voltage direct current (HVDC) systems with line-commutated converters - Part 3: Dynamic conditions

Guidelines for administrative, medical and nursing staff concerned with the safe use of medical electrical equipment and medical electrical systems

Guidance concerning the permissible temperature rise for parts of electrical equipment, in particular for terminals

Method for verifying accuracy of tan delta measurements applicable to capacitors

Electromagnetic compatibility (EMC) - Part 1-1: General - Application and interpretation of fundamental definitions and terms

Electromagnetic compatibility (EMC) - Part 1-3: General - The effects of high-altitude EMP (HEMP) on civil equipment and systems

Electromagnetic compatibility (EMC) - Part 1-4: General - Historical rationale for the limitation of power-frequency conducted harmonic current emissions from equipment, in the frequency range up to 2 kHz

Electromagnetic compatibility (EMC) - Part 1-5: General - High power electromagnetic (HPEM) effects on civil systems

Electromagnetic compatibility (EMC) - Part 1-6: General - Guide to the assessment of measurement uncertainty

Electromagnetic compatibility (EMC) - Part 1-7: General - Power factor in single-phase systems under non-sinusoidal conditions

Electromagnetic compatibility - Part 1-8: Phase angles of harmonic current emissions and voltages in the public supply networks - Future expectations

Electromagnetic compatibility (EMC) - Part 1-9: General - Evaluation of uncertainty for the measurement of harmonic current emissions

Electromagnetic compatibility (EMC) - Part 2: Environment - Section 1: Description of the environment - Electromagnetic environment for low-frequency conducted disturbances and signalling in public power supply systems

Electromagnetic compatibility (EMC) - Part 2-14: Environment - Overvoltages on public electricity distribution networks